The at2k, a great gun once modded, before, not so much. Some of the time the darts don’t even leave the barrel.
So lets mod this bad boy. Here’s a pic of it un-modded :
4x6-8 in. of Cpvc
Hot glue gun
A working brain ( I know some of you don’t have this ;))
1.Remove all screws. It should look like this:
2. Remove the pump from the pump tube and plug it with your hot glue gun. Once your done, place it back in.
3.Remove the turret from the case.
Make sure you keep this piece right here right here, the o-ring:
4. Cut off the end of the barrels with your hacksaw about ¼ or1/8 in. from base type thing. You should see springs and junk,
keep on going, and in the middle you should hit a medal post, you want to swerve around that, because it would be a lot more
work that is necessary to but through it. This is what it should look like:
5.Cut 4 6-8 inch segments, but make them all the same length, as if you don't make them the same length you will get varied
6.Take your turret, and hot glue your cpvc barrels. The best way to do this is to do it 1 at a time, and glue the turret and
the barrels, then stick it on, and then glue around it.
7. Place the o-ring back in the turret back, and place the turret on the valve. It should fit back together perfect.
8. Screw it altogether.
IF YOU DON'T LIKE THE MUSIC, TURN OFF YOUR VOLUME, LAZY'S.
2005 all rights rezerved. We support Nerf X.